Inside a finished freezer room with insulated panel walls and ceiling-mounted evaporators

Cold rooms and lifts, built properly.

Tundra Construction builds cold rooms and freezers and installs lifts across South East Queensland.

Request a quote

A finished room looks simple.

Freezer room. Panel walls and ceiling, evaporators in.

What decides how long it lasts is the part nobody sees.

Joints, floors and door hardware. When they are not sealed properly, moisture gets in, ice follows, and the room starts working against itself.

Broken door heater frame on a freezer, with ice building up around it
Corroded base of a freezer panel where it meets the slab

Door heater frame broken and icing up, before repair.

A full-height insulated wall panel being stood upright by forklift inside a concrete shed

Every wall starts with one panel.

Stood, checked and fixed.

Then the next one.

Red vapour barrier laid wall to wall across a freezer floor, with every lap taped
Steel reinforcing mesh set out over the same floor, ready for concrete

Under the floor.

Vapour barrier, wall to wall, taped at every lap.

Steel mesh, set out for the slab. Then the concrete goes down and nobody sees any of it again.

Built for the job in front of us.

From a walk-in behind a kitchen to a freezer the size of a warehouse bay. Panel, floors, doors and hardware, built to stay sealed.

Display cool room with a wall of glass doors, built inside a shop fit-out
Glass-door display room
Walk-in cold room interior with evaporator and insulated door
Walk-in cold room
Wide view inside a large freezer room with panel walls and ceiling
Freezer room
Mobile cold room on a trailer with its service doors open, outside the Tundra workshop
Mobile cold room
Cold room work
Looking up a concrete lift shaft with guide rails and brackets installed
Lift machine sheave with hoist ropes fitted

Lifts

Lift installation, done in the shaft.

We rig the shaft, set the rails, build the car and finish each landing. Careful, measured work in a space with no room for error.

  • Shaft rigging and hoisting
  • Guide rails and brackets
  • Car, sling and machine installation
  • Landing doors and finishes
Lift work

Tell us what you need built.

A call is the fastest way to a quote. Send drawings or a few photos and we will come back with a price.

0498 398 004
Request a quote
Email
[email protected]
Workshop
6/40 Junction Dr
Coolum Beach QLD 4573
Working across
South East Queensland